Stone washing machine drum, drum, sand washing machine drum sand washing machine, cylindrical stone washing machine Introduction 

 The drum washing stone, also known as cylinder wash machine stone roller stone washing machine is mainly used for the the desliming operating artificial aggregates to less than 80mm aggregate. Feed particle size, washed aggregate clay content may be less than 0.5%, moisture content of less than 2% of the advantages of. 

 Stone washing machine drum, drum, sand washing machine, drum sand washing machine, cylindrical stone washing machine works 

 The roller stone washing machine cleaning cylinder four tugs support motor driven reducer, the size of the gear drive cleaning cylinder low-speed rotation. Aggregate containing clay in powder feed inlet to the entry into the rotating drum, to a certain point of view of wear resistant rubber liner installed in the cleaning roller constantly brought up into the falling material from the feed end to end mobile the course of several cycles, and forward or reverse rinse water will rinse wash, clean aggregate sieve dehydration after discharge through the discharge end of the tube screen. Wastewater containing sludge by the outflow of feed or feed end of the perforated baffle. 

 Stone washing machine drum, drum, sand washing machine, drum sand washing machine, cylindrical stone washing machine operating procedures 

 1, stone washing machine before the start of the first rotating the rotor by hand, check the machine ministries any abnormal phenomenon. 
 2, and use should be based on site-specific circumstances, the protective equipment installed on the V-belt in order to operate. 
 3, the operation is not available to repair and clean-up work boot repair is strictly prohibited. 
 Not allowed to join stone washing machine more than the required size of the stone materials. The machine shall be fixed direction of rotation, shall not reverse rotation. 
 In the stone washing machine operation, such as abnormal vibration or sound, you should immediately stop feeding to be inside the material is drained, immediately stop the motor down to check and troubleshooting in order to continue operation. Encounter 
 , Tight to stop the motor, the material must be removed before the boot cavity, no-load start. The workplace should not put their things, and there must be enough light for the lighting.